Oblique Sony a6100 Payload Kit

Optimized to map vertical structures, the Oblique Sony ɑ6100 allows you to generate high-resolution 3D meshes with centimeter-level absolute accuracy.

Optimised for 3D

WingtraOne’s oblique solution with the fast-triggering ɑ6100 camera and wide-angle 12 mm optics in a tilted mount makes for the optimal solution to map 3D structures, from single buildings to full-scale cities.

A low-oblique configuration

The WingtraOne oblique solution combines the high-end Sony a6100 camera with a wide-angle 12mm lens in a tilted mount and low-oblique configuration.

If you are mapping bare earth or open fields, a camera looking straight down is the best solution, because the different points in your image are the same distance from your camera.

If you want to map 3D structures like buildings or highwalls, you want to capture enough detail on the vertical walls. A low-oblique configuration provides a wide field of view to the front and sides, making it the best solution to capture a maximum of detail.

Specifications

Sensor type:
24 MP APS-C

Lowest GSD:
1.6 cm/px Multispectral

Coverage at 120m:
180 ha at 3.9 cm/px GSD*

Absolute horizontal accuracy down to:
2 cm** Without GCPs

Horizontal field of view:
90° (-45° … 45°)

Vertical field of view:
66° (-18° … 48°) tilted to the front

* For successful 3D mapping, high side and front overlaps are recommended. The specified numbers refer to the suggested default values of 80% side and 85% front overlap
** Horizontal absolute accuracy (RMS). Achievable with a WingtraOne GEN II and its built-in GNSS PPK module. This level of accuracy is achievable under optimal conditions, on hard surfaces, using a well-established base station or data from a CORS network. A minimum of three ground points should be used as checkpoints to verify and prove the accuracy of the project.